User Manual
Table Of Contents
- Introduction
- Features
- In The Box
- Specifications
- Troubleshooting Lights - Transmitter/Receiver
- Troubleshooting Lights (HDBaseT Port)
- Transmitter Ports
- Receiver Ports
- IR Configuration
- Audio
- EDID Management - Transmitter
- EDID Copy Instructions
- RS-232 Configuration
- Troubleshooting
- Bandwith Chart
- Maintenance
- Damage Requiring Service
- Support
- Warranty
14
Troubleshooting
·Verify Power - Check that the power supply is properly connected and on an active circuit.
·Verify Connections - Check that all cables are properly connected.
·TX/RX Indicator Troubleshooting Lights - Pg. 5-6
·IR Issues - Verify correct connections - P. 8-9
Note: Visibly ashing Emitters may not function properly, if you are experiencing issue try the
IR Cables that come in the box.
·Lights indicate everything is good but still not getting a picture, this may be a bandwith lim-
itation. See Bandwith Chart below to verify the signal is not exceeding the bandwith of the
Extender kit (limited to 10.2Gbps).
Bandwith Chart