User Manual
Table Of Contents
- Introduction
- Features
- In The Box
- Specifications
- Troubleshooting Lights - Transmitter/Receiver
- Troubleshooting Lights (HDBaseT Port)
- Transmitter Ports
- Receiver Ports
- IR Configuration
- Audio
- EDID Management - Transmitter
- EDID Copy Instructions
- RS-232 Configuration
- Troubleshooting
- Bandwith Chart
- Maintenance
- Damage Requiring Service
- Support
- Warranty
8
IR Conguration
There are three dierent 3.5mm IR ports located on the Transmitter and Receiver.
IR OUT - This port is designed to accept an IR Emitter
In the example below an IR recieving eye is plugged into the “IR IN” port of the HDBaseT Transmit-
ter, and a IR Emitter is plugged into the “IR OUT” port of the HDBaseT Receiver. This allows you to
use an IR Remote control to send and IR signal from the source side (TX) down the category cable to
the sync (RX) and control the display.