Specifications

3000 series eurocard switchers.ib.rev21.doc Page 8 of 36 16/10/2007
CDC-3060: programmed data controller for 3000 series switchers.
RS232 input / output:
Number 1.
Type 9600 baud. (8 bit word, no parity, 1 stop)
Connectors 9 pin ‘D’.
Format 8 bit data word comprising:
1 command bit
2 address bits
5 crosspoint number bits - BCD encoded.
Switcher control input/output:
Type 5 bit BCD coded parallel TTL level.
Number 1.
Connector Plug in 10 pin HE14 dual IDC.
Performance:
Switching Determined by type of switchers connected.
Power consumption <50 mA.
CP-700: 5 x 1 remote pushbutton panel for wire per crosspoint switchers.
Type Momentary action with removable clear cap for legend insert. Red LED
indicator in one corner.
Number 5
Control connector 9 pin 'D'.
Switching Dumb contact to ground only. Performance is entirely dependent on
connected switchers.
Power consumption Approximately 10 mA per active LED derived from connected switcher if
tally enabled.
Dimensions 128 mm x 30 mm front panel
Depth 30 mm clearance including connectors.
Mechanical May be mounted in a standard IRT Eurocard frame if required, but does
not connect to motherboard.
Mounting hole - with front panel 114 mm x 28 mm.
Mounting hole - switches only 81 mm x 17 mm.
CPS-9000 & 9001: 5 x 1 remote pushbutton panel for 3000 series switchers.
Type Momentary action with removable clear cap for legend insert. Red LED
indicator in one corner.
Number 5
Control inputs/outputs:
Type 5 bit BCD coded parallel TTL level.
Number 1 “input” & 1 “output”.
Connectors Plug in 10 pin HE14 dual IDC.
Switching Determined by type of switchers connected; but not more than 25 ms.
Timing of connected switchers may be synchronised to a master switcher.
Power consumption Derived from connected switcher.
Up to 4 x CP-9000 or 9001’s may be connected to one switcher (or
CDC-3060) without exceeding power rating specified for switcher.
Dimensions 128 mm x 30 mm front panel.
Depth 60 mm front panel to end of PCB.
80 mm clearance including connectors.
Mechanical May be mounted in a standard IRT Eurocard frame if required, but does
not connect to motherboard.
Mounting hole - with front panel 114 mm x 28 mm.
Mounting hole - switches only 81 mm x 17 mm.