Instruction Manual

3. Connect Decoder’s RF2 outlet to Magic eye’s input socket using male to

male IEC connector Coaxial cable.

4. Plug in the mains for both TV and Decoder, switch both devices on.

5. Red light on the Magic eye should be on, place the IR receiver where it

will be seen by the remote. (Usually on top or by side of the TV).

6. You Magic eye is ready to use.

Note: If Magic eye is not in function at the end of the installation, please refer to

Satellite Decoder manual on how to activate RF2 output. For tuning satellite

channel please refer to your TV Manual.

Spec:

Input Signal Frequency 38kHz Carrier (lnfra Red System)

Output Signal Frequency On-Off Keyed 6MHz Carrier

Line power Requirement 9V DC @15mA

Infra Red Sensor Lead 0.9m

Output Connector IEC Male

lnput Connector IEC Female

Operating Temperature 0°C to +40°C

Errors and omissions excepted.