Manual

IO-ADPT

IO LINK – RF ADAPTOR

Item ref: 124.158UK

User Manual

Thank-you for choosing this IO Link RF adaptor. Designed for use with satellite boxes that do not

have an RF2 output. This device converts the I/O port to an RF2 output allowing the use of a TV link

or magic eye remote extender. The adaptor also has a RF loop through input to allow reception of

DTV signal for additional TV sets.

Specification:

I/O Input 10 pin din plug on 240mm lead

RF Input RF socket

RF Output RF plug (channel 21 – 69)

Dimension 60 x 50 x 21mm

Weight 75g

Installation:

Before installation please ensure that both TV and Sky box are disconnected from mains power.

 Connect adaptor to satellite box through the 10-pin DIN connector ensuring it is correctly in-

line.

 Connect RF output to a magic eye device and then connect to the TV.

 Connect UHF aerial to RF input (if required).

PAGE 1
IO-ADPT IO LINK – RF ADAPTOR Item ref: 124.158UK User Manual Thank-you for choosing this IO Link RF adaptor. Designed for use with satellite boxes that do not have an RF2 output. This device converts the I/O port to an RF2 output allowing the use of a TV link or magic eye remote extender. The adaptor also has a RF loop through input to allow reception of DTV signal for additional TV sets.
PAGE 2
For set-ups with more than one TV, a distribution amplifier with DC pass facility can be used, such as Mercury’s AMD & AMS ranges. See diagram below: Set-up For the adaptor to work correctly, RF output power must be switched on via the satellite box. To activate your IO Link adaptor on a Sky+HD box:  Using your Sky remote control press “SERVICES”.  Press “0” then “0”then “1” then “SELECT” to enter the installer set-up menu.