MAWB-A30 CLAMP ON WIDEBAND MIXER AERIAL Diplexer Item ref: 130.
INTRODUCTION: Thank you for choosing this Mercury aerial. This aerial is designed for the reception of FM, DAB and UHF digital TV signals. It is designed to clamp onto a satellite dish and does not need a mast. With a built-in low noise signal amplifier and mixer, it boosts the signals and transmits them along the same coaxial cable as the satellite signal.
Step 2: Position the aerial on top of the dish with dipole box at the back of the satellite dish, ensure the Mercury logo is facing outward. Put the mounting clamps over the edge of the satellite dish one by one and attach the loose end back on the aerial. Turn the thumbscrew clockwise to tighten the aerial in position. Step 3: Attach the two securing clips to the aerial elements, one on each side and slide the clips towards the mounting clamp, this prevents the aerial detaching from the mounting clamps.
Step 6: On existing installations, connect the cable removed from LNB to the mix output on the aerial. Otherwise run the cable neatly to the satellite receiver. Step 7: At the end of the cable connect the diplexer as shown in the diagram below. (To split the satellite and terrestrial signal). Connect SAT on the diplexer to the SAT in on the satellite receiver and Ter on the diplexer to TV set top box (or directly from Ter on the diplexer to TV if it is digital TV compatible).