MAUHF-A27 4G READY CLAMP ON UHF MIXER AERIAL Diplexer Item ref: 130.
INTRODUCTION: Thank you for choosing this Mercury aerial. This aerial is designed for the reception of UHF digital TV signals. It is designed to clamp onto a satellite dish and does not need a mast. With a built in low noise signal amplifier and mixer, it boosts the signals and transmits them along the same coax cable as the satellite signal.
Step 2: Position the aerial on top of the dish with dipole box at the back of the satellite dish, ensure the Mercury logo is facing outward. Put the mounting clamps over the edge of the satellite dish one by one and attach the loose end back on the aerial. Turn the thumbscrew clockwise to tighten the aerial in position. Step 3: Undo the screws that hold LNB on the support beam, disconnect the cable from LNB output if it is an existing installation.
Step 6: At the end of the cable connect the diplexer as shown in the diagram below. (To split the satellite and terrestrial signal). Connect SAT on the diplexer to the SAT in on the satellite receiver and Ter on the diplexer to TV set top box (or directly from Ter on the diplexer to TV if it is digital TV compatible). Some satellite receivers such as SKY box, have an RF in function which means the Ter output can be plugged into RF in socket, this will require a F-plug to RF plug lead.
