LED DERBY III RGBW Light Effect Item ref: 151.
Caution: Please read this manual carefully before operating Damage caused by misuse is not covered by the warranty Introduction Thank you for choosing the QTX LED DERBY III quad colour multi-point effect as part of your lighting rig. Please read these instructions in full to gain the best results from this item and avoid damage to the unit. Unpacking Your LED DERBY III should reach you in good condition and be supplied with appropriate mains lead(s) and mounting bracket.
Setting up Install the LED DERBY III so that the front panel is facing the area to be lighted. Experiment with positioning to get the best coverage from the multi-beam array. Connect mains using an appropriate IEC lead to the mains inlet Operation The LED DERBY III operates as a stand-alone unit in either auto or sound-activated modes. Settings are accessible via the 10 dip switches situated on the rear panel. Sound activated mode is governed by a rotary sensitivity control on the rear panel.
Specifications Power supply Power consumption Operating modes LED sources Controls Dimensions Weight 240Vac 50Hz (IEC) 40W Auto, Sound activated 8 x 3W LED (2 x Red, 2 x green, 2 x blue, 2 x white) Power on/off, Mic. Sensitivity, dip switches 1-10 295 x 160 x 275mm (inc. bracket) 3.
