Owner manual
154.012UK User Manual
Control panel settings
Display
Mode
Press ENTER for setting (press FUNC to exit)
DMX address
to
Slave mode
= slave mode active
DMX channel mode
, , , , (see appendix)
Fixture ID setting
to
- Panel lock
/ (see “Note: Panel Lock” section above)
/ (ID mode on/off)
- RGB limit mode
= enable RGB preset limit = disable RGB limit
- display dimmer
= display off after 15s = constant display
Sound activated
/ (sound on/off)
RGB preset limit
(red 0-255)
(green 0-255)
(blue 0-255)
Software version
(displays software version)
Static colour & strobe
(red 0-255)
(green 0-255)
(blue 0-255)
(white 0-255)
(strobe speed)
Auto program 1-2
[press enter again] (speed)
Sound activated mode
(sound activated programs 1-2)
Custom settings
The control panel has various options to modify the behaviour of the WSL-Q7.
/ setting enables several WSL-Q7 fixtures to be controlled as a DMX group
(Setting 2 units to and another 2 units to will allow control as 2 pairs)
/ setting allows the user to set the WSL-Q7 as white mode or RGBW fixture
/ when set to , the LED display will go out 15secs after no button pushes
(LED display automatically lights again when any control panel buttons are pressed)
controls balance of red / green / blue colour elements to suit the application
(e.g. in a room with a lot of red surfaces, it may be preferred to reduce the red level)
Standalone operation
Static colour or single colour strobing is selectable via the option on the control panel.
When the red, green, blue, white colour levels are set, sets the strobe speed.
If a more dynamic effect is needed, 2 programs can be selected.
When the auto program is selected, pressing ENTER again enables speed adjustment.
2 sound activated options are also available responding to the internal microphone.