QTFX-B2 Bubble Machine User Manual 160.
User Manual – QTFX-B2 160.563UK QTFX-B2 Bubble Machine – For indoor use only Caution! Please read this manual carefully before operating! Damage caused by misuse is not covered by the warranty! 1. General Introduction : A portable bubble machine with high quality fan and motor to produce the best bubbles possible for your party. Features : High bubble output High speed fan with low noise Easy to empty and clean tank For best results to be used with QTX Light bubble fluid 160.
User Manual – QTFX-B2 160.563UK 15. Technical specification : User Manual – QTFX-B2 2. 160.563UK Package Contents : Power supply 230Vac, 50Hz Please check the contents to ensure that the product has been received in Fuse F1A good condition. Power consumption 40W RPM 20 QTFX B2 bubble machine x 1pcs Dimensions 290 x 240 x 220mm Power Cord x 1pcs Weight 2.
User Manual – QTFX-B2 4. 160.563UK Setup : 1. Unpack the bubble machine. 2. Place on a flat surface. 3. Pour the contents of the bubble fluid into the front tank so the User Manual – QTFX-B2 160.563UK 12. Rear Layout: bubble wands at the bottom of the wheel are completely submerged. 4. Connect the IEC mains plug and power up. 5. After use unplug from the mains and empty the remaining contents back in to the bubble fluid container or dispose of appropriately. 6.
User Manual – QTFX-B2 160.563UK 11. Layout: User Manual – QTFX-B2 160.563UK 5. Mounting instruction : The fixture may be mounted in any position provided there is adequate room for ventilation and the fluid can not leak. It is important never to obstruct the front of the machine, fan or vents pathway. Mount the fixture using a secure clamp. Adjust the angle of the fixture loosening both knobs and tilting the fixture. After finding desired position, re-tighten both knobs.
User Manual – QTFX-B2 160.563UK 160.563UK Do not use the device during thunderstorms and please disconnect the power. User Manual – QTFX-B2 8. Replacing Fuse : Do not use solvents or aggressive detergent to clean the device. Use a soft and clean cloth. Disconnect from the main power supply first, then remove the fuse holder Do not modify the device or the connected power cord without above the IEC Socket to reveal the fuse. Replace the correct fuse rating as authorization.