SW-2 SNOW MACHINE Item ref: 160.
Caution: Please read this manual carefully before operating Damage caused by misuse is not covered by the warranty Introduction Thank you for choosing the SW-2 DMX snow machine for stage and events special effects. This product is designed to produce high volume snow output on demand for festive and themed events. Please read these instructions in full to gain the best results from this item and avoid damage to the unit through misuse.
Rear Panel 1. 2. 3. 4. 5. 6. 7. DIP switches for DMX address setting DMX input (3-pin XLRM) DMX output (3-pin XLRF) Power on/off rocker switch Mains inlet (IEC male) and fuse holder Remote control connection (5-pin DIN) Fluid level indicator Setting up The SW-2 requires snow fluid, which forms small foam drops to create the snow effect. It is recommended to use qtx snow fluid for best results (160.578, 160.579) A chart for recommended fluids is included further along in this document.
Make sure that the remote control rocker switch (11) is set to the “off” position at startup Switch the mains power on (4) at the rear of the unit And the power indicator (10) will light Set the output control (8) to the lowest setting and switch the rocker switch on The snow effect indicator (9) will light to show that the fan is active Adjust the output control to the required density of snow pumped into the nozzle when active Switch the rocker switch off to stop the fan and thus stop the eff
Troubleshooting No light on mains switch No power light on remote No snow output when using remote control No snow output when using DMX control Check mains voltage is correct and socket is switched on Check IEC lead is OK and connected properly Check mains fuse in IEC connector and fuse in plug top If fuse blowing repeatedly, refer to qualified service personnel Check remote control is connected properly Check snow fluid level Check that rocker switch is on and output control is turned up Check that nozz
160.
