M8S ACTIVE SUBWOOFER 8” Order ref: 170.
Introduction Thank you for choosing the AV Link M8S active subwoofer as part of your sound system. This product is designed with flexibility and reliability in mind to offer long-lasting, high quality output for many varied applications. Please read this manual fully and follow the instructions to achieve the best results with your new purchase and to avoid damage through misuse. Warning To prevent the risk of fire or electric shock, do not expose any of the components to rain or moisture.
Connection Connect the M8S to the mains using the mains lead supplied or an equivalent, good quality fig.8 mains lead. Ensure that the mains voltage is as stated on the rear panel and the outlet has sufficient capacity to operate the sub. Determine how the sub unit is to be configured. If already operating a stereo amplifier with 2 speakers, the M8S can be configured to “tap off” a signal from the amplifier output without affecting the power output of the left and right speakers.
Troubleshooting No power light on rear panel Power light is on but no output Output is very distorted or “flapping” sound is heard from speaker cone Output is working but at very low level Ensure IEC inlet is connected to mains and mains lead is in good condition Ensure mains outlet is switched on Ensure POWER switch is on Check mains fuse and replace if necessary with an approved type T1A fuse 5x20mm.
