Owner's manual

ManualsBrandsAVSL ManualsAudio accessories170.860 CL1002

CL1002 mixer 170.860

CLP1002 powered mixer 170.870

User Manual

Features:

 Internal 16 program DSP effects

 6 Mic/Line + 2 Stereo Line channels

 3-band EQ per channel

 +48V phantom power

 19” rack-mounting kit included

 2 x 7-band master graphic EQ

 AUX Send and Return

 CLP models with internal stereo power amp

www.citronic.com

Summary of content (6 pages)

PAGE 1
CL1002 mixer 170.860 CLP1002 powered mixer 170.870 User Manual Features:         Internal 16 program DSP effects 6 Mic/Line + 2 Stereo Line channels 3-band EQ per channel +48V phantom power 19” rack-mounting kit included 2 x 7-band master graphic EQ AUX Send and Return CLP models with internal stereo power amp www.citronic.
PAGE 2
Introduction: Thank you for choosing this Citronic CL/CLP series mixer. This product has been designed to offer reliable, high quality mixing for stage and/or studio applications with unfailing consistency. In order to gain the best results from this equipment and avoid damage through misuse, please read and follow these instructions and retain for future reference. Warning: To prevent the risk of fire or electric shock, do not expose any of the components to rain or moisture.
PAGE 3
Channel Strip 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. XLR microphone or low impedance line input Stereo line inputs 6.3mm jack unbalanced Mono line input 6.
PAGE 4
Rear Panel 30. 31. 32. 33. 34. IEC mains inlet & fuse POWER switch PHANTOM power switch Speaker outputs (CLP1002 only) Cooling vents Connection Before connecting to amplifier, speakers or other equipment, turn down all volume controls to avoid loud noises which may cause damage to other equipment. Always switch amplifier power on last in line with volume levels down. Using good quality 6.
PAGE 5
Checking Set all HIGH, MID, LOW and PAN controls to the mid position (12o’clock) and AUX/DSP controls fully left (-∞) Test each channel’s gain level by pressing in the PFL (Pre-Fade Listen) switch. If any PFL switches are on, the VU meters will display the output of the PFL channel(s) instead of the overall output. Make the loudest expected sound through that channel and increase the GAIN control until the signal reaches the 0dB mark.
PAGE 6
Troubleshooting No power LED on control panel Power LED is on but no other LEDs and no output Power light and VU LEDs lighting but no output No output from stereo channels VU LEDs do not show MASTER output level Output is very loud or distorted Output is working but at very low level Feedback (loud squealing or howling from mics) Ensure power lead is in good condition and connected properly Ensure mains outlet voltage is as stated on adapter Check internal fuse – if blowing fuses, refer to service pe