Owner's manual

Rear Panel
Connection
Before connecting to amplifier, speakers or other equipment, turn down all volume controls to avoid loud noises which may
cause damage to other equipment. Always switch amplifier power on last in line with volume levels down.
Using good quality 6.3mm jack or XLR leads (balanced or unbalanced), connect L + R MASTER outputs from the mixer to the
amplifier, recorder or whichever equipment is to receive the main mix output.
If phantom power is to be used, switch in the PHANTOM on the rear panel
Connect microphones, DI boxes and other balanced low impedance audio inputs to the mono channels using a quality XLR lead.
Connect high impedance and line level signals to the mono inputs using a 6.3mm jack lead.
For stereo channels, connect left and right line level signals via 6.3mm jack – use left only for mono signals.
An additional 2 TRACK input is provided for playback devices on stereo RCA connectors and recording equipment can be
connected via the “REC” outputs using a twin RCA lead
The 6.3mm jack AUX SEND can be connected to monitoring or external processing equipment if required and the output of
external processing equipment can be brought back into the mix by connecting it to AUX RETURN.
For monitoring, headphones can be connected to the 6.3mm stereo HEADPHONES jack.
For CLP models, connect speakers via the LEFT and RIGHT Speaker Outputs on the rear panel, ensuring that the combined
load on each channel is no lower than 4Ω and the speakers are capable of the amplifier’s rated output.
With all faders down, connect the supplied mains lead to the mains supply and IEC inlet (ensure correct supply voltage). Switch
POWER on and the power LED will illuminate (if phantom power is selected, this LED should light also)
30. IEC mains inlet & fuse
31. POWER switch
32. PHANTOM power switch
33. Speaker outputs (CLP1002 only)
34. Cooling vents