PRO-2 MKII Citronic 2 Channel DJ Mixer Order ref: 172.
Introduction Thank you for purchasing the Citronic PRO-2 MKII 2 Channel DJ Mixer. This product is intended to give long term, reliable service in normal usage. Please read these instructions before use to avoid incorrect operation and to help outline the functions and controls. Maintenance There are no user serviceable parts inside, refer all servicing issues to qualified service personnel. Clean with a lint-free dry or damp cloth.
Controls: 1. MICROPHONE LEVEL – Individual level for DJ microphone. 2. CHANNEL GAIN – Trim control for stereo inputs. 3. MICROPHONE HI EQ – Hi frequency cut/boost for mic inputs. 4. CHANNEL Hi EQ – High frequency cut/boost for each stereo channel. 5. MICROPHONE LO EQ – Lo frequency cut/boost for mic inputs. 6. CHANNEL LO EQ – Lo frequency cut/boost for each stereo channel. 7. CHANNEL PHONO/LINE – Input selector for channel 1/2 phono or line input.
8. CHANNEL FADER – Individual volume fader for each stereo channel. 9. VU METER: Volume unit’s LED’s to indicate status of output signal. 10. CROSSFADER – Allows seamless fading between channels 1 & 2. 11. MICROPHONE INPUT – 6.3mm JACK input for a DJ microphone. 12. MASTER VOLUME – Sets the overall output level to the amplifier 13. CUE LEVEL – Set the CUE volume level for the headphones 14. CUE MIX – Rotate to mix between CH1 and CH2 in the headphones. 15. HEADPHONE INPUT – 6.
Connection Guide: Operation: • • Only use the supplied power supply. Connect any turntables to the RCA PHONO inputs on ch.1 and ch.2. • Earth turntables (unless they are self-grounded) to the case grounding point on the rear panel • Connect CD, CD+G, laptop, TV decoder, DVD or MP3 players to LINE inputs. • Connect DJ mic and headphones at the front. • With MASTER LEVEL, MICROPHONE LEVEL, CHANNEL FADERS and GAINS Turned down, switch the power on.
Troubleshooting: NO OUTPUT Check power switch is on Check leads and connections Check MASTER LEVEL and mic or channel fader is turned up Check CROSSFADER position Check your sound source is playing Check if the input switch is set to LINE or PHONO DISTORTED OUTPUT Check line input isn't connected to PHONO Check GAIN input levels Check channel and MASTER faders are not too high Check volume control of amplifier, active speakers or recording equipment MICROPHONE FEEDBACK & OUTPUT Eliminate “line-of-sight” bet
Specification: Power supply 12Vac, 500mA Headphone output 32 ohms, 1.