Operation Manual

CAMIP18
V. 01 – 14/02/2014 5 ©Velleman nv
PoE (Power over Ethernet) Connection
The camera features PoE (Power over Ethernet). If your router or hub supports PoE, you do not need to
connect the camera to a power socket. You can then connect the camera as shown below:
8
PoE router/hub
9
LAN cable
10
camera
11
power
1. Use a network cable [9] to connect your camera [10] to a PoE port of your router [8].
2. Make sure your router is connected to a power socket [11].
Note: If your router does not support PoE, you can use a PoE injector (not included) to use the PoE
feature.
7. Software Configuration
The installation method below describes the setup with an iPhone® with a D-Link® wireless router and
modem. The installation procedure is similar for iPad® or Android™ devices. Refer to the full manual on
the included CD-ROM for more information.
Prerequisites
Before proceeding, check the following:
• We recommend that you use your own ADSL or cable internet service for easy network configuration.
• Your camera is connected to your wireless router with an 8P8C network cable, and it is powered on.
• EagleEyes-Lite or EagleEyes-Plus is installed on your device.
If not, download it from your device’s app store.
Note: EagleEyes HD for iPad does not support network configuration. Please install EagleEyes-Lite or
EagleEyes Plus on your iPad instead.
Preparing the Network Configuration
1. Connect your camera to your wireless router using an 8P8C network cable (see “Overview” above).
2. Write down the IP address of your wireless router. You will need it later. To find the IP address,
proceed as follows:
3.
Connect your mobile device to the wireless router
that has the camera connected.
4. Go to Settings > WiFi.
5. Press the “>” button to see the details of the
selected wireless network.
The IP address is visible next to “Router”.
(In the sample screen, the IP address is
192.168.2.1)
Adding Your Camera to the EagleEyes App
1. Establish a wireless connection between your mobile device and the wireless router that has the
camera connected.
2. Open the EagleEyes app and click the “+” button to add a new device.