User manual

FREQUENTLY-USED FUNCTIONS
11
4.3 IP Device Search
Note: This function is available only for “SUPERVISOR”. To know more details, please refer to “4.4 User
Level Creation” at page 12.
Click (IP Search) to start searching IP camera(s) connected in the same network segment as the NVR (i.e.
10.1.1.xx by default).
You’ll see the list of every connected IP camera with its connection status to this NVR and MAC address.
IP SEARCH
IP PORT MAC PROTOCOL STATUS
10.1.1.12 88 00:0e:53:e5:9a:f1 AVTECH CONNECTED TO CH1
10.1.1.13 88 00:0e:53:a6:91:18 AVTECH CONNECTED TO CH2
10.1.1.14 88 00:0e:53:a5:9f:a2 AVTECH UNUSED
10.1.1.15 88 00:0e:53:e1:4e:k5 ONVIF CONNECTED TO CH3
10.1.1.16 88 00:0e:53:s5:3e:h6 ONVIF CONNECTED TO CH4
10.1.1.17 88 00:0e:53:e6:4b:26 ONVIF CONNECTED TO CH5
10.1.1.18 88 00:0e:53:g2:3b:e7 AVTECH CONNECTED TO CH6
 CONNECT SETUP EXIT
To fix the camera IP address, or allow the NVR to assign an IP address to your IP camera, select “SETUP”, and
select “STATIC IP “ or “DHCP” for “NETWORK TYPE”.
Click “APPLY” and “EXIT” to save your changes.
SETUP
NETWORK TYPE DHCP
IP 10.1.1.14
PORT 80
USER NAME admin
PASSWORD *****
NETMASK 255.0.0.0
GATEWAY 10.1.1.10
PRIMARY DNS 168.95.1.1
APPLY EXIT
To connect to another IP camera, select the unused IP camera from the IP search list, and select “CONNECT”.
Select the channel you want to display the camera images, and click “SAVE” to start connection.
CONNECT
IP 10.1.1.14
PORT 88
CHANNEL CH5
USER NAME admin
PASSWORD *****
SAVE CANCEL