User's Manual

HELPFUL DIAGRAMS
6 7
AVT4MR Receiver
Power
Switch
Botón de
Encendido
IR Sync
Window
Channel A
Controls
Channel B
Controls
Channel C
Controls
Channel D
Controls
Receiver
Controller
Controlador
Recibidor
Power
Cord Input
Entrada de
Cable de
Energia
Mixed 1/4”
TRS Output*
Mezcla de
Salida Cable
Antennae
Location
XLR Channel
Outputs
Antennae
Location
FRONT
BACK
Product may differ from photos
*Must use XLR cables to control channels independently.
A. Receiver Controller - Use the receiver con-
troller to toggle through options, select
channels (A through D) and set the frequen-
cies of the transmitters.
B. Group Select - By selecting this option via
the receiver controller you can select a
group of preset frequencies for all 4 of your
transmitters/receiver channels. Each trans-
mitter would still need to go through the IR
Sync function if not already in Sync.
C. IR Sync - This mode allows you to IR Sync
your transmitters individually with your re-
ceiver. See the detailed explanation below.
Note: Using Group select will pick four different
preset frequencies for each of your trans-
mitters. You will still need to use IR Sync
to sync each transmitter with the receiver.
Other Functions:
Volume Control - The volume of each
channel can be adjusted using the
individual volume control knobs.
Note: It is possible to use one 1/4" cable to for
all 4 channels. However, a cleaner signal
may be obtained if you use 4 individual
XLR cables. Using XLR cables will also
allow the sound man to adjust each of the
transmitters sound levels individually
when away from the receiver with the use
of a mixing board.
Note: It is suggested that the transmitters have
at least 3 or more full frequencies of dis-
tance between each other to help prevent
interference with each other. For exam-
ple: If the first transmitter is on 471.000
MHz then make sure that the second
transmitter is at least on 474.000 MHz or
greater distance from the selected fre-
quency of the first transmitter.
Step 1. Make sure all other microphone receiv-
ers and transmitters in the room are
turned off except for the receiver and
transmitter you are trying to sync.
Step 2. By using the receiver controller select a
receiver channel for which you would
like to sync a transmitter and access
sync mode. You can use one channel
per transmitter. One transmitter can
sync to A, the second can sync to B,
the third to C, and the fourth transmitter
can sync to D.
Step 3. After completing the previous step the
receiver should now be ready to sync
for the channel you have chosen. Now
hold the powered on transmitter up to
Further Instructions Regarding IR Sync Mode:
the receiver with the IR window of the
transmitter facing toward the "IR" win-
dow on the receiver. See diagram on
preceding page to find location on your
receiver. Also see pages 10-12 for more
information.
Step 4. After successfully completing the IR
Sync procedure repeat the same proce-
dure for all 4 transmitters choosing a
different channel (A, B, C or D) for each
transmitter. Each transmitter must be
on a different frequency. If you have two
receiver channels on the same frequen-
cy then change the frequency or "chan-
nel" for one transmitter.
Four Microphone System
LCD Display
(frequency
displayed here)
Four Microphone System