4 Microphone Wireless Systems Sistema de 4 micrófonos inalámbricos USERS MANUAL for Professional Series Models: › AVT-QUAD1 › AVT-QUAD2 › AVT-QUAD2B (AVT-4BP1 and AVT-4BP2 Beltpack Transmitters) Please read and keep for future reference. Distributed by: www.avtronicsworld.
FCC INFORMATION AVT-QUAD1R and AVT-QUAD2R Receiver: TRANSMITTER SPECIFICS AVT-QUAD1 and AVT-4BP1 Handheld Transmitters: Channel A (Purple) Channel B (Yellow) Channel C (Pink) Channel D (Gray) 696.65 MHz 693.65 MHz 631.75 MHz 625.15 MHz FCC ID: Y3I-AVTQUADHH8 FCC ID: Y3I-AVTQUADHH7 FCC ID: Y3I-AVTQUADHH6 FCC ID: Y3I-AVTQUADHH5 Beltpack Transmitters: Channel A (Purple) Channel B (Yellow) Channel C (Pink) Channel D (Gray) 696.65 MHz 693.65 MHz 631.75 MHz 625.
Congratulations on purchasing a fine wireless microphone system from AVTronics. This product should give you trouble free service throughout it’s life. We trust you will enjoy it’s performance.
HELPFUL DIAGRAMS FRONT Power Switch Channel A Volume Control Channel B Volume Control Channel C Volume Control Channel D Volume Control Botón de de Control de Control de Control de ( Encendido ) (Control Volumén ) ( Volumén ) ( Volumén ) ( Volumén ) BACK (Actual frequencies will vary by model) Channel D XLR Output Channel C XLR Output Channel B XLR Output (Canales de las Salidas XLR) Channel A XLR Output Mixed 1⁄4” TRS Output Mezcla de (Salida Cable ) Power Cord Input ( Opening the device m
RECEIVER BELTPACK On/Off Switch Botón de ( Encendido ) On/Off Switch Botón de (Encendido ) color coded by frequency de color (codigo de frecuencia ) color coded by frequency de color (codigo de frecuencia ) CAUTION! To lower the risk of potentially harmful electric shocks please do not perform any of the following procedures: › Do not disassemble, remove screws, or otherwise in any way open the enclosure. › Keep receiver and transmitters away from water including rain and moisture.
GETTING STARTED Step 1 Verify that all equipment including the sound system is turned off. Step 2 Attach power supply cord to receiver. Step 3 Make sure you have batteries in each transmitter that you plan to use. Step 4 Plug power supply cord from receiver into the wall. Step 5 Plug receiver into sound system. Do this by either plugging in each channel using the XLR outputs on the back of the receiver (each channel requires one XLR cable) or by connecting one 1⁄4” cable to the sound board.
CÓMO CONECTAR EL EQUIPO Paso 1 Verifique que todo el equipo incluyendo el sistema de sonido este apagado. Paso 2 Conecte el cable del suplidor de energía al recibidor. Paso 3 Asegurese que tiene baterías para cada transmisor que usted se proponga usar. Paso 4 Conecte el suplidor de energía del recibidor a la pared. Paso 5 Conecte el recibidor al sistema de sonido.
www.avtronicsworld.
