Users Manual

RF24L01F20 Module

Button Operation :

Press the button to enter Tx Mode. An image is taken with an onboard camera and sent on a

fixed channel saved during the Scan Mode .

Note: The device doesn’t save the parameter setting in non-volatile memory. All the settings

are lost on power off and the device goes to Scan Mode on powerup.

Note: The antenna(s) used for the transmitter must not be co-located or operating in

conjunction with any other transmitter or antenna.

Only those antenna(s) tested with the device or similar antenna(s) with equal or

lesser gain may be used with the transmitter.

FCC Information and Copyright

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that interference will

not occur in a particular installation. If this equipment does cause harmful interference to

radio or television reception, which can be determined by turning the equipment off and on,

the user is encouraged to try to correct the interference by one or more of the following

measures:

—Reorient or relocate the receiving antenna. —Increase the separation between the

equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to which the receiver

is connected.

—Consult the dealer or an experienced radio/TV technician for help.

15.19 Labelling requirements. This device complies with part 15 of the FCC Rules. Operation

is subject to the following two conditions:

1 )This device may not cause harmful interference, and

2 ) this device must accept any interference received, including interference that may cause

undesired operation.