User Manual
Camera Management
NVR User Manual
29
Add Manually
Input the IP address or domain name (click in the IP address column to pop up the domain
name input window, input the domain name of the IPC in the window and then click “OK”
button), port, username and password of the camera and then select the protocol. Click “Test”
to test the effectiveness of the input information and then click “Add” button (you can input
one camera’s information or above such as IP address, username and password before clicking
“Add” button). Click to delete the camera. Click “Default Password” to set the default
username and password of each camera.
Note: Some models may not support this function.
Click StartSettingsSystemBasicGeneral Settings to check “Enable Add IPC by
Zero Operation”. If the NVR has unoccupied channels, it can add IPC without any operation
by restarting.
Add Recorder
Quickly Add:Select the searched NVR/DVR and the click “Add” to add NVR in the
same local network.
Manually Add:Click “Manual Add” and then input the IP address or domain name,
port, username and password of the NVR/DVR. Check the added remote channel
number and click “Test” to test the effectiveness of the input information. Then click
“OK” button to return to the previous interface.