User Manual
Alarm Management
NVR User Manual
73
Check “Draw Area” and then click around the area where you want to set as the warning area
in the image (the warning area should be a closed area). Uncheck the “Draw Warning Area” if
you finish the drawing. Click “Clear” button to delete the warning area.
⑤ Click “Apply” to save the settings.
⑥ Click “Processing Mode” to go to the alarm handling configuration interface of object
detection.
Object Detection Alarm Handling Configuration:
① Click StartSettingsAlarmIntelligence AlarmObject Detection to go to the
following interface.
② Enable or disable “Snapshot”, “Push”, “Alarm-out”, “Preset”, “Buzzer”, “Pop-up Video”
and “E-mail”. The alarm handling setting of object detection alarm is similar to that of the
sensor alarm (see 9.1 Sensor Alarm for details).
③ Click “Apply” to save the settings. You can click “Article Protect Config” to go to the
object detection configuration interface.