User Manual

Alarm Management
NVR User Manual
80
9.5.4 Buzzer
Click StartSettingsAlarmEvent NotificationBuzzer to go to the buzzer configuration
interface. Set the delay time of the buzzer and then click “Apply” to save the setting. You can
click “Test” to test the buzzer.
9.5.5 Push Message
Click StartSettingsAlarmEvent NotificationPush Message to go to the interface as
shown below. Check “Enable” and then click “Apply” button to save the settings. If Push
Server is online, it will push messages to the mobile clients.
9.6 Manual Alarm
Click on the tool bar at the bottom of the live preview interface to pop up a window. Click
“Trigger” to start alarm. Click “Clear” to stop alarm.