User Manual

Device Management
NVR User Manual
98
11.2 Basic Configuration
11.2.1 Common Configuration
Click StartSettingsSystemBasicGeneral Settings to go to the following interface. Set
the device name, device No., language, video format and main output. Enable or disable wizard,
“Log In Automatically”, “Log Out Automatically” (if checked, you can set the wait time),
“App Live Self-Adaption” and “Dwell Automatically” (if checked, you can set the wait time).
Click “Apply” to save the settings.
Device Name: The name of the device. It may display on the client end or CMS that help user
to recognize the device remotely.
Video Format: Two modes: PAL and NTSC. Select the video format according to the camera.
Dwell Automatically: Check it and set “wait time”.The system will dwell automatically if it is
not operated during the time you set.
Note: You can set the resolutions of the main output and adjuvant output respectively if the
NVR has dual outputs. Refer to the picture as shown below.