User Manual

Wizard & Main Interface
NVR User Manual
21
Click to edit the searched IP camera as shown on the below left. Input the new IP address,
subnet mask, gateway, username and the password of the camera. You can check “Sync to IPC”
to modify the IP address of the IPC via different network segments for being in the same
network segment with the NVR. Click “OK” to save the settings.
Click to edit the added camera as shown on the above right. Input the new camera name,
IP address, port, username and the password of the camera. You can click “Test” to test the
effectiveness of the input information. Click “OK” to save the settings. You can change the IP
camera name only when the added camera is online. Click “Next” to continue.
⑤ Disk Settings. You can view the disk number, disk capacity of the NVR and serial number,
R&W status of the disk. Click “Formatting” to format the disk. Click “Next” to continue.