User Manual

Record & Disk Management
NVR User Manual
54
7.1.2 Advanced Configuration
Click StartSettingsRecordAdvanced to go to the following interface. Enable or disable
cycle record (cycle record: the earliest record data will be replaced by the latest when the disks
are full). Set the pre-alarm record time, post-alarm record time and expiration time of each
camera and then click “Apply” to save the settings.
Pre-alarm Record Time: set the time to record before the actual recording begins.
Post-alarm Record Time: set the time to record after the actual recording is finished.
Expiration Time: set the expiration time for recorded video. If the set date is overdue, the
recorded data will be deleted automatically.
7.2 Encode Parameters Setting
Click StartSettingsRecordEncode Parameters to go to the interface as shown below. Set
the encode, resolution, FPS, GOP, bitrate type, quality, max bitrate and audio of main stream
for each camera in “Event Recording Settings” and “Schedule Recording Settings” interfaces.
Click “Apply” to save the settings. You can set the record stream of each camera one by one or
batch set them for all cameras.
Click StartSettingsRecordStream Settings to go to “Sub-stream” interface. Set the
encode, resolution, FPS, GOP, bitrate type, quality and max bitrate of sub-stream for each
camera in the interface and then click “Apply” to save the settings.