User Manual

Alarm Management

NVR User Manual

Check “Draw Area” and then click around the area where you want to set as the warning area

in the image (the warning area should be a closed area). Uncheck the “Draw Warning Area” if

you finish the drawing. Click “Clear” button to delete the warning area.

⑤ Click “Apply” to save the settings.

⑥ Click “Processing Mode” to go to the alarm handling configuration interface of object

detection.

Object Detection Alarm Handling Configuration:

① Click StartSettingsAlarmIntelligence AlarmObject Detection to go to the

following interface.

② Enable or disable “Snapshot”, “Push”, “Alarm-out”, “Preset”, “Buzzer”, “Pop-up Video”

and “E-mail”. The alarm handling setting of object detection alarm is similar to that of the

sensor alarm (see 9.1 Sensor Alarm for details).

③ Click “Apply” to save the settings. You can click “Article Protect Config” to go to the

object detection configuration interface.