User Manual

Device Management
NVR User Manual
92
through IE, you should input IP address plus HTTP port in the IE address bar like
http://192.168.11.61:81.
HTTPS Port: the default HTTP port of the NVR is 443.
Server Port: the default server port of the NVR is 6036. The server port number can be
changed as required. The port is mainly used in network video management system.
RTSP Port: RTSP real-time stream protocol can be used to control the sending of real-time data.
By media player which supports the RTSP real-time stream protocol, you can view the live
images synchronously. The default RTSP port is 554 and it can be changed as required.
11.1.3 PPPoE Configuration
Click StartSettingsNetworkPPPoE to go to the interface as shown below. Check
“Enable” in “PPPoE Settings” and then input the username and password obtained from the
dealer. Click “Apply” to save the settings.
11.1.4 DDNS Configuration
The DDNS is used to control the dynamic IP address through domain name. You can access to
the NVR easily if the DDNS is enabled and configured.
Click StartSettingsNetworkDDNS to go to the interface as shown below.
Note: The HTTP port and server port of the NVR should be mapped to the router before you access
the NVR via WAN.