Manual

2 Basic Operation Guide
2.1 Startup & Shutdown
2.2 Remote Controller
10
Please make sure all the connections are done properly before you power on the
unit. Proper startup and shutdown are crucial to extending the life of your
device.
Key points to check in case the remote doesn’t work.
1. Check batteries polarity.
2. Check the remaining charge in the batteries.
3. Check IR controller sensor for any masking.
If it still doesn’t work, please change a new remote controller to try, or contact
your dealers. You can just turn the IR sensor of the remote controller towards the
IR receiver of the DVR to control it when you are controlling multiple devices by
remote controller.
There are two kinds of remote controller. The interface of remote controller is
shown as below.
You can power o the device by using remote controller or mouse.
By remote controller:
2.1.1 Startup
①
②
③
Connect the output display device to the VGA/HDMI interface of the NVR.
Connect with the mouse and power. The device will boot and the power
LED would turn blue.
A WIZARD window will pop up (you should select the display language the
first time you use the DVR). Refer to 3.1 Startup Wizard for details.
①
②
③
④
It uses two AAA size batteries.
Open the battery cover of the remote controller.
Place batteries. Please take care the polarity (+ and -).
Replace the battery cover.
2.1.2 Shutdown
①
②
Press Power button. This will take you to a shutdown window. The unit will
power oafter a while by clicking “OK” button.
Disconnect the power.
By mouse:
①
②
Click StartShutdown to pop up the Shutdown window. Select "Shutdown"
in the window and click “OK” button. The unit will power o after a while after
verifying the username and password.
Disconnect the power.