Manual

PTZ

Click in the camera list on the right side of the interface to display the cruise

information of the dome and then click on the top right corner of the cruise

to delete the cruise.



Delete Cruise

Click StartSettingsCameraPTZProtocol to go to the interface as shown

below. You can enable or disable the PTZ and set the protocol, baud rate and

address of the analog dome in the interface. Please make sure the analog

speed dome camera is well connected to the DVR before you control it.

Select the camera and enable PTZ and then set the protocol, baud rate and

address of the dome according to the settings of the dome.

Protocol: The default communication protocol of the DVR is COC. Range from:

PELCOP, PELCOD, LILIN, MINKING, NEON, STAR, VIDO, DSCP, VISCA, COC, etc.

Address: The address of the PTZ device.

Baud Rate: Baud rate of the PTZ device. Range from: 110, 300, 600, 1200, 2400,

4800, 9600, 19200, 34800, 57600, 115200, 230400, 460800, 921600.

6.4 PTZ Protocol Setting