Instruction manual

E-10
TROUBLESHOOTING GUIDE
If you have a problem, please check the following chart to see if you can fix it before consulting a
servicing professional.
Symptom Possible Cause Solution
Radio
Channel is not tuned properly
for AM or FM
Fine tune the AM or FM broadcast
station
FM: The FM antenna wire is not
extended
Extend the FM wire antenna fully
Noise or sound is distorted
on AM or FM broadcasts
AM : The built-in ferrite bar
antenna is not positioned
correctly
Reposition/rotate the unit until the best
reception is obtained
Band in mono mode Press ST/MO button to enter STEREO
mode
You have tuned to a mono
station
Retune to another FM station
FM STEREO indicator
does not light up
The station signal is too weak Retune to another FM station
The unit is not in TUNER mode Press TUNER / BAND button to enter
TUNER mode
No sound in AM or FM
Volume is at the minimum
position
Adjust the volume level
CD Player
The unit is not in CD mode Press “CD” button to enter CD mode CD player does not play
CD is not placed or placed
incorrectly
Load disc with unlabelled side facing
downwards
CD skips while playing Disc is dirty or scratched Clean disc with cloth or use another
disc
RESETTING THE UNIT
If the system does not respond, you may have experienced a severe electric shock or a power surge
that triggered the internal computer to automatically shut down. If this occurs, disconnect the unit from
the AC power outlet and reconnect it again after a few seconds.