User's Manual

Vaccines for Children |

Installation and Setup Guide

o Red – The tag and probe are not communicating. Unplug the probe cable

and reattach. If the red LED still shows, RMA the tag.

o Green – LF message received and probe and tag are communicating.

o Red/Green Consecutively Multiple Times – The probe and cable are not

communicating because of a bad probe. Unplug the probe cable and

reattach. If you still receive the red/green LED, RMA the probe.

o 3 x Green = Good Tag/probe (only when battery or probe replaced)

5. Curl the cord through the loop of the Tag.

6. Close the casing.

4.3.2 Provisioning the Environmental Tag

After a device (tag, display, or beacon) has been batch created, it must be provisioned

so that it can connect to the network and provide location information for tags. Use the

following procedure to provision a device.

NOTE: Before beginning this procedure, an Awarepoint router must be connected

and running close to the tablet running the provisioning application.

Without this router, the SSID for the site will not be available to the app

and the provisioning procedure will fail.

1. Open the Provisioning app on the Awarepoint tablet.

Figure 2 Provisioning Application Main Screen

The following areas should be noted as identified in the figure above:

1) Application version

2) The Environment URL drop-down list

3) The REQUEST TOKEN button

4) The SYNC WITH SITES FROM IP button