User's Manual

24
Vaccines for Children |
Installation and Setup Guide
Figure 7 Example Probe Storage Placement
If a pre-drilled hole through the wall of the asset is available, or a manufacturer’s access
point in the back of the asset, use this existing access point to thread the probe wire into
the asset. If a pre-drilled hole is not available, discuss the possibility of having the
Client’s engineering team drill a hole in the back of the unit for this purpose.
If you are unable to install the probe through the back of the asset or through a hole,
you may thread the wire through the door with written customer documentation to
support the decision to go through the door. If existing temperature monitoring devices
are in place, attempt to install the Awarepoint temperature vial as close to these as
possible. If no temperature-monitoring device exists, install the vial as far back from the
front door of the unit as possible to reduce fluctuations in readings caused by opening
the asset door.
To install the Environmental Tag:
1. Ensure that the TAG MAC is visible and place the Tag on the outside of the
temperature asset using 2 pieces of VHB tape affixed to the back of the unit.