User's Manual

25
Vaccines for Children |
Installation and Setup Guide
Press the Tag firmly against the asset for approximately 30 seconds to ensure
bonding.
2. Feed the probe through any service port on top, back, or side of device.
If a service port or other opening isn’t available, it is recommended that a hole be
drilled so the cord may pass through and the hole sealed after tag installation.
This is not always possible.
3. Using a zip tie and anchor, make a service loop of any excess cord in order to
relieve tension if it is pulled.
For best results, two loops should be placed on the device, one outside and one
inside. A bow shape achieves the best results.
The Tag must be placed on the outside of the asset with the bar code facing
forward or up for easy reading/scanning.
4.3.4 Tag Configuration and Map Placement
VFC Tag and Display devices must have the proper configurations to ensure efficiency.
Additionally, for non-BLE deployments, Tags and Displays must be placed on a facility
map manually. These procedures are performed in System Manager.
4.3.4.1 Tag Configuration Settings
1. In System Manager, select Config > Device Config.
2. From the list of devices on the left, select BT-E to show the configuration settings
for Environmental Tags.