User's Manual

31
Vaccines for Children |
Installation and Setup Guide
To move the device, click the Move link, then click and drag the icon to the new
location.
Click Cancel to cancel the operation and remove the icon.
Click Remove to remove the device icon, then click Ok at the confirmation
dialog.
The Awarepoint tag connects directly to the appliance over WiFi. In an MSE
environment, System Manager configures the tag to use either Broadcast or TCP for
samples and configuration.
4.3.5 Tag Network Connectivity
There are two options for VFC tag network connectivity, direct connect and connection
through the appliance.
4.3.5.1 Tag Direct Connect
When the tag is configured with Direct Connect enabled, it connects directly to the
Awarepoint Appliance to send sample indications rather than sending via WiFi blink.
Perform the following procedure to configure the tag for direct connect:
1. Pair the VFC tag with its display.
NOTE: Only environmental tags and displays can be paired.
Only environmental tags and displays that have already been batch created can
be paired. If you have not batch created the devices, do so first before
continuing with the following procedure.
a. In System Manager, from the Devices tab drop-down, select Env.
Tag/Display Pairings.
b. From the Environmental Tag/Display Pairings window, locate the device
(environmental tag) you want to pair with a display in the Environmental Tag
column.
NOTE: If you are on the Display to Environmental Tag Pairings tab, the first
column would be Display, showing all environmental displays. The
procedure, however, is still similar for pairing.