User's Manual

34
Vaccines for Children |
Installation and Setup Guide
• Mounting
These procedures must be done in the order described or the system may not work.
4.3.6.1 Batch Creating and Pairing
Batch creating and pairing of the VFC Display is done following the procedures
previously described.
• Batch creating
• Pairing
4.3.6.2 Battery Installation and Powering On
Perform the following procedure to install the battery and power on the VFC Display:
NOTE: These procedures must be completed within 5 minutes of the
Environmental Tag’s first signal input to Infopoint. If not, the Tag and
Display will wait 30 minutes before attempting to contact each other again
in order to preserve battery life.
1. On the back of the VFC Display, locate the battery cover.
2. Using your thumb, apply some pressure to the ridged area with the area and
slide the cover away from the display.
3. Attach the 9-volt battery to the battery connector.