User's Manual
Table Of Contents
- 1 Introduction
- 2 Installation Steps
- 3 Step #1 – Configure Regions
- 4 Step #2 – Preparing for Installation
- 5 Step #3 – Installing the Appliance
- 6 Step #4 – Installing the Bridge
- 7 Step #5 – Installing the Sensors
- 8 Step #6 – Installing the Tags
- 9 Step #7 – Associating the Tags with Assets
- 10 Step #8 – System Testing and Quality Control
- 11 Adding Additional Assets After Installation
- 12 Troubleshooting
Step #1 – Configure Regions 14
Installation Guide v2.3 – 5/10
Confidential and Proprietary ©2010, Awarepoint Corporation
3.2.6 Setting Map Scale
For each floor in the facility, using a laser distance reader, select the longest
measurable distance and measure this distance in meters. Record this distance.
Open the System Manager and choose the Areas tab. Load the map of the floor to be
scaled. On the left side of the map, choose the bottom button Set Map Scale.
Figure 22 - Setting Map Scale
Find the area on the map where the distance was measured. Click on one end of the
measured length. While holding down the mouse button, drag the dotted line to the
other end of the measured distance. Release the mouse button. Enter the segment
length in meters.
Figure 23 - Enter Segment Length