User's Manual
Table Of Contents
- 1 Introduction
- 2 Installation Steps
- 3 Step #1 – Configure Regions
- 4 Step #2 – Preparing for Installation
- 5 Step #3 – Installing the Appliance
- 6 Step #4 – Installing the Bridge
- 7 Step #5 – Installing the Sensors
- 8 Step #6 – Installing the Tags
- 9 Step #7 – Associating the Tags with Assets
- 10 Step #8 – System Testing and Quality Control
- 11 Adding Additional Assets After Installation
- 12 Troubleshooting
Step #3 – Installing the Appliance 24
Installation Guide v2.3 – 5/10
Confidential and Proprietary ©2010, Awarepoint Corporation
5.6 Initial Set-up
Run “awp-network-config.sh” to run the configuration utility. The script displays
the main menu.:
hostname: aps.awarepoint.com
1) configure hostname
2) configure eth0
3) configure dns
4) test network
q) quit
5.7 Configure IP Address
Select option 2, “configure eth0”
eth0 is enabled
using dhcp
eth0 Link encap:Ethernet HWaddr 00:0C:29:18:FB:48
inet addr:192.168.1.175 Bcast:192.168.1.255 Mask:255.255.255.0
inet6 addr: fe80::20c:29ff:fe18:fb48/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:2746 errors:0 dropped:0 overruns:0 frame:0
TX packets:154 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:291745 (284.9 KiB) TX bytes:16965 (16.5 KiB)
Interrupt:177 Base address:0x1400
1) Use DHCP
2) Manually configure
3) Restart interface
4) Enable Device
5) Disable Device
q) quit
▪ If DHCP select option 1, “Use DHCP”
▪ If Static, select option 2, “Manually Configure,” and enter the Awarepoint
Appliance’s IP address information.
(Note: examples shown below)
IP Address: 192.168.1.173
Netmask: 255.255.255.0
Gateway (default route): 192.168.1.1
Press “q” to return to the main menu.
When asked to restart the network, choose yes (y).
changes were made restart network [y/n]?