User's Manual
Table Of Contents
- 1 Introduction
- 2 Installation Steps
- 3 Step #1 – Configure Regions
- 4 Step #2 – Preparing for Installation
- 5 Step #3 – Installing the Appliance
- 6 Step #4 – Installing the Bridge
- 7 Step #5 – Installing the Sensors
- 8 Step #6 – Installing the Tags
- 9 Step #7 – Associating the Tags with Assets
- 10 Step #8 – System Testing and Quality Control
- 11 Adding Additional Assets After Installation
- 12 Troubleshooting
Step #4 – Installing the Bridge 27
Installation Guide v2.3 – 5/10
Confidential and Proprietary ©2010, Awarepoint Corporation
Figure 30 - B2 Bridge
▪ Cursor
▪ Down Arrow
▪ Up Arrow
▪ Enter
The Bridge menu can be entered at any time by holding down the Cursor and Enter
buttons simultaneously.
Figure 31 - Entering the Bridge Menu
These are the menu options:
▪ Configuration
▪ Info
▪ Ping
▪ Exit
Choose one of the menu options by pressing the Cursor button until it is under the
menu option. Press the Enter button to get into the selected menu.
Configuration allows the user to configure the below options.
▪ Auto-Negotiation Link – Yes/No
Figure 32 - Auto-Negotiation Link