User's Manual
Table Of Contents
- 1 Introduction
- 2 Installation Steps
- 3 Step #1 – Configure Regions
- 4 Step #2 – Preparing for Installation
- 5 Step #3 – Installing the Appliance
- 6 Step #4 – Installing the Bridge
- 7 Step #5 – Installing the Sensors
- 8 Step #6 – Installing the Tags
- 9 Step #7 – Associating the Tags with Assets
- 10 Step #8 – System Testing and Quality Control
- 11 Adding Additional Assets After Installation
- 12 Troubleshooting
iii
Installation Guide v2.3 – 5/10
Confidential and Proprietary ©2010, Awarepoint Corporation
Regulatory Compliance: The Awarepoint devices have received the following agency approvals:
Bridge Model B1: FCC ID: UAG-00000000B100 (FCC Part 15.247)
Bridge Model B2: FCC ID: UAG-B2 (FCC Part 15.247)
IC ID: 7348A-B2 (IS RSS-210, Issue 7)
FCC Part 15:2007, Class A (Radiated & Conducted)
EN55022:2006, Class A (Radiated & Conducted)
ICES-003:2004, Class A (Radiated & Conducted)
Sensor Model S1: FCC ID: UAG-00000000R100 (FCC Part 15.247)
UL 60950-1:2003
CSA C22.2 No. 60950-1:2003
Sensor Model S2: FCC ID: UAG-S2 (FCC Part 15.247)
IC ID: 7348A-S2 (IS RSS-210, Issue 7)
UL 60950-1:/R:2007-10
CSA C22.2 No. 60950-1:2003
Sensor Model S2U: FCC ID: UAG-S2 (FCC Part 15.247)
IC ID: 7348A-S2 (IS RSS-210, Issue 7)
IEC 60950-1:2005
Sensor Model S2C: FCC ID: UAG-RM1 (FCC Part 15.247)
IC ID: 7348A-RM1 (IS RSS-210, Issue 7)
IEC 60950-1:2005
Tag Model T1: FCC ID: UAG-00000000T100 (FCC Part 15.247)
Tag Model T2: FCC ID: UAG-T2 (FCC Part 15.247)
IC ID: 7348A-T2 (IS RSS-210, Issue 7)
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this Device may not cause harmful interference and (2) this Device must accept any interference
received, including Interference that may cause undesired operation.
CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
CAUTION: S2C and devices with RM1 modules transmits low power microwave energy. Although this
energy is not harmful, these devices should be installed 20cm away from a human body to guarantee
compliance with maximum allowable permissible exposure.
CAUTION: This manual describes installation procedures for electrical equipment. Proper precautions are
required. Particular attention should be given to text highlighted with the following symbol: