User's Manual
Table Of Contents
- 1 Introduction
- 2 Installation Steps
- 3 Step #1 – Configure Regions
- 4 Step #2 – Preparing for Installation
- 5 Step #3 – Installing the Appliance
- 6 Step #4 – Installing the Bridge
- 7 Step #5 – Installing the Sensors
- 8 Step #6 – Installing the Tags
- 9 Step #7 – Associating the Tags with Assets
- 10 Step #8 – System Testing and Quality Control
- 11 Adding Additional Assets After Installation
- 12 Troubleshooting
Step #4 – Installing the Bridge 34
Installation Guide v2.3 – 5/10
Confidential and Proprietary ©2010, Awarepoint Corporation
Figure 49 - Placing Awarepoint Bridge
Bridges can also be placed using the B button on the left side of the map. This method
of placing Bridges on the map is helpful if the list of unassigned Bridges is very long.
Choose the B button and then type in the last 5 digits of the Bridge’s MAC address.
Choose OK. The Bridge will appear in the center of the map. It can then be moved to
the appropriate location.
Note: Use caution to only reposition the added Bridge, and not a Bridge that has
already been placed on the map.
Figure 50 - Placing Awarepoint Bridge Using B Button
Choose the Apply button to save the changes.