User's Manual
Table Of Contents
- 1 Introduction
- 2 Installation Steps
- 3 Step #1 – Configure Regions
- 4 Step #2 – Preparing for Installation
- 5 Step #3 – Installing the Appliance
- 6 Step #4 – Installing the Bridge
- 7 Step #5 – Installing the Sensors
- 8 Step #6 – Installing the Tags
- 9 Step #7 – Associating the Tags with Assets
- 10 Step #8 – System Testing and Quality Control
- 11 Adding Additional Assets After Installation
- 12 Troubleshooting
Step #6 – Installing the Tags 44
Installation Guide v2.3 – 5/10
Confidential and Proprietary ©2010, Awarepoint Corporation
Figure 63 - Tag Zip Tie Attachment
Figure 64 - Tag Double-Sided Tape Attachment
Write down the MAC address and asset information, including:
▪ Type of Asset (Wheelchair, IV Pump, Gurney, etc.)
▪ Nickname, if any (for example, Gurney #1)
▪ Department that it belongs to, if any
▪ Manufacturer
▪ Model
▪ Serial Number
▪ Asset Control Number
▪ Unique Identifier – for most installations this is the facility’s asset ID number