Full Product Manual

7. Straighten the front bar; making sure the awning is level and straight.
8. Screw both camelback hinges into the wall.
9. Remove middle screw on the hinge and attach the Arms (eye end
attached to the hinge). Tighten screw in slot.
10. Optional Pulley:
Install tie down cleat on the side with the two pulleys. (4-6”
below the bottom of the awning)
Tie one end of the pull cord to the left front bar of the awning, thread
through left side pulley, then over closet right side pulley and down to the
cleat and back up to open right pulley, tie the end of pull cord to the right
and left side of the front bar. Draw all slack in pull cord towards cleat and
tie off. (Shown Below)