Instructions / Assembly

Traditional & Classic Awning Assembly and Mounting
1. Unscrew the screw on each side of awning releasing the eye end from the
camelback hinge
2. If have Optional pulley system installed
(IF NO PULLEY SYSTEM IS INSTALLED SKIP TO #3)
a) Remove pulley on the left head rod clamp hook. Remove two
pulleys on the side with the pull cord.
b) Untie cord from front bar
3. Remove wing nuts from head rod clamp allowing you to remove awning from
wall
4. Lay awning on a clean surface
5. Slide the Head Rod bar out of head rod pocket (set aside)
6. Unscrew side bar from elbow and remove out of side bar pocket (do the same
on both sides)
7. Unscrew elbow from front bar (do the same on both sides)
8. Slide front bar out of front bar packet(set aside)
9. Remove plastic from New Replacement cover .
a) Slide the front bar into the front bar pocket. (Located near the
valance of awning)
b) Slide the Arms into the side pocket of awning.
c) Screw elbows on to front bar.
d) Screw side arms onto elbow
e) Slide head rod bar into head rod pocket
10. Holding awning by head rod bar place into head rod clamps and tighten wing
nuts onto head rod clamp securing awning to wall.
11. Straighten the front bar; making sure the awning is level and straight.
12. Remove middle screw on the hinge and attach the Arms (eye end attached
to the hinge). Tighten screw in slot.