Installation Guide

ManualsBrandsAwnings in a Box ManualsAwnings8 ft. Designer Awning Replacement Cover (36.5 in. Projection) in Tuxedo

Basic Tools Required (not included)

 Phillips Screwdriver



Ladder

Note: Make sure that the awning cover you purchased exceeds the window width.

Allow for clearance for windows or doors that open outward.

General Comments



Wash your hands before installation when handling the fabric.



Always be careful with the fabric during installation.

Drills, screwdrivers and other items can puncture the fabric.

Punctures during installation are not covered by the warranty.



A second person to assist in holding the awning during installation is RECOMMENDED.

Included in Awning Kit

Item

Part Number

Description

Awning Designer

4ft

6ft

8ft

1410760

Instruction Sheet

N/A

Awning Fabric Cover

Installation Instructions

Replacement Covers For

Designer Awnings in a box™

Instructions

Sheet

#3 Unscrew Nuts on all

head rod clamps sides

#1 Unscrew

this screw on

both sides

#5 Slide head rod bar

out

#6 Unscrew T connectors on

both sides from side arms

#7 Unscrew T connectors on

both sides of front bar

#8 Slide front

bar out

Summary of content (4 pages)

PAGE 1
Installation Instructions Replacement Covers For Designer Awnings in a box™ Basic Tools Required (not included)   Phillips Screwdriver Ladder Note: Make sure that the awning cover you purchased exceeds the window width. Allow for clearance for windows or doors that open outward. General Comments  Wash your hands before installation when handling the fabric.  Always be careful with the fabric during installation. Drills, screwdrivers and other items can puncture the fabric.
PAGE 2
Designer Awning Assembly and Mounting 1. Unscrew the screw on each side of awning releasing the eye end from the camelback hinge. 2. If have Optional pulley system installed (IF NO PULLEY SYSTEM IS INSTALLED SKIP TO #3) a) Remove pulley on the left head rod clamp hook. Remove two pulleys on the side with the pull cord. b) Untie cord from front bar 3. Remove wing nuts from head rod clamp allowing you to remove awning from wall 4. Lay awning on a clean surface 5.
PAGE 3
13. Optional Pulley: a) Tie one end of the pull cord to the left front bar of the awning, thread through left side pulley, then over closet right side pulley and down to the cleat and back up to open right pulley, tie the end of pull cord to the right and left side of the front bar. Draw all slack in pull cord towards cleat and tie off.
PAGE 4
Customer satisfaction and end user satisfaction is a number one concern and priority. THE WARRANTY Warranties apply for 1 year from date of original purchase with proof of purchase (original receipt) Customer satisfaction and end user satisfaction is a number one concern and priority.