Full Product Manual

ManualsBrandsAwnings in a Box ManualsAwnings6 ft. Designer Manually Retractable Awning (36.5 in. Projection) in Charcoal Gray

Basic Tools Required

(not included)

•

Tape Measure & Pencil Level

• Phillips Screwdriver

•

Ladder

•

Drill with

⅛

” bit (Cement or Masonry bit for concrete installation)

•

Additional Hardware may be needed for non-standard installation

Note:

Make sure that the awning you purchased exceeds the window width.

Allow for clearance for windows or doors that open outward.

General Comments

•

Wash your hands before installation when handling the fabric.

•

Always be careful with the fabric during installation.

Drills, screwdrivers and other items can puncture the fabric.

Punctures during installation are not covered by the warranty.

•

A second person to assist in holding the awning during installation is RECOMMENDED.

Included in Awning

Kit

Item Part Number

Description Awning Designer

4 ft.

6 ft.

8 ft.

1200145

Head Rod Clamps

1200170

Powder-Coated Black

Hinges w/bolts

1200171

Powder-Coated Black

Eye Ends

(Already attached to M)

1200094

Powder-Coated Black

Screws

#10 (1 ½”)

1200172

Powder-Coated Black

“T”- Connectors

1200146

Pulleys

1200720

Internal Connectors

1200176

Powder-Coated Black

Cleat

Installation Instructions

Designer Awnings in a box™

Summary of content (6 pages)

PAGE 1
Installation Instructions Designer Awnings in a box™ Basic Tools Required (not included) • • • • • Tape Measure & Pencil Level Phillips Screwdriver Ladder Drill with ⅛” bit (Cement or Masonry bit for concrete installation) Additional Hardware may be needed for non-standard installation Note: Make sure that the awning you purchased exceeds the window width. Allow for clearance for windows or doors that open outward. General Comments • Wash your hands before installation when handling the fabric.
PAGE 2
I Powder-Coated Black Finials (Already attached to N) 1200180 J 1410760 K 1020010 L N/A M 2 1 1 1 1 1 1 1 1 1 2 2 2 2 2 2 2 2 2 1300225 (Inside / Outside Threaded Pipe) 2 2 2 1300223 Center Bar (Inside Threaded Pipe both ends) 0 2 4 3 Yards Awning Fabric Cover Powder-Coated Black Arm Bar (Outside Threaded Pipe both ends) (Already attached to C) Powder-Coated Black 4” Finial Bar (Already attached to I) 1300258 O 2 Instructions Sheet Instruction Sheet 1300262 N
PAGE 3
Designer Awning Assembly and Mounting 1. Measure and mark wall for head rod clamps 6 inches in from both sides of the window. a) Drill pilot or anchor holes for each head rod clamp. b) Fasten both head rod clamps to the wall, use a level to ensure clamps will be level with each other and centered above window. WINDOW 2. Assemble the Head Rod bar using the internal connector. There should be one 2 ft.
PAGE 4
7. Measure 36" down from head rod on each side of awning and attach camelback hinges to wall making sure arms are straight when viewed from front. a. Optional: Decreasing this dimension will increase the awnings projection from wall to clear door openings if desired. 8. Remove middle screw on the camelback hinge. 9. Attach eye ends side of arm pipe to wall mounted camelback hinges. 10. Put arm pipe through hole in fabric. 11. Screw finial into T Connectors. 12.
PAGE 5
Product Care and Maintenance We use only quality fabrics in the manufacturing of our products, but fabrics do have a few limitations; therefore, proper care of your awning is important to extend its life. • • • • • • Clean awning fabric with a mild soap solution as needed (every 3 months), rinse thoroughly with water and allow to air dry (never put fabrics in your dryer). Keep the underside of your awning clean by brushing with a household broom.
PAGE 6
THE WARRANTY Warranties apply for 1 year from date of original purchase with proof of purchase (original receipt) Awnings in a Box™ Frame and Hardware - 1 Year Warranty Fabric – 1 Year Limited Warranty against manufacturer’s defects in the fabric or sewing • • • Up to 3 months from the date of purchase full replacement of item includes shipping cover only Over 3 months and under 6 months from the date of purchase customer pays 50% of new item cover only Over 6 months and under 1 year from the date of purch