User Manual

LED indications
Blinks continuously: self-testing
Blinks once: Motion is detected
Blinks twice: self-testing is complete; entering working mode Blinks once every 3
seconds: the batteries must be replaced.
Connection to your alarm system
The detectors in your kit are already connected and ready to use. If you have
deleted the detector from the control panel, you can reconnect it as follows:
1. Press once on the Connection button located on the control panel.
2. Press the Test button at the back of the detector. The control panel will beep
once acknowledging the connection. If the control panel beeps twice, the
detector was already connected.
Specifications
Power supply: DC 3V (AA 1.5V LR6 Batteries x 2)
Static current: ≤ 30 uA
Alarm current: ≤ 15 mA
Detection scope: 8 m / 110°
Transmission distance: ≤ 80 m (in open area)
Radio-frequency: 868 MHz
Housing material: ABS plastic
Operating conditions: 0°C~50°C, Humidity: ≤ 80% (non-condensing)
Dimensions (L x W x H): Detector: 107 x 53 x 32 mm, Bracket: 52 x 30 x 26.5 mm