User Manual

WaveCom Electronics Inc
MA4040D Manual; MAN1L0901 REV 13(0104)
Approved: D.P.
14
ALARM LED
The red MA4040D ALARM indicator has two modes. A flashing Alarm LED indicates a non-critical alarm condition
(i.e. soft alarm). A constant Alarm LED indicates a critical alarm condition (i.e. hard alarm). Detailed alarm
information is available by selecting the corresponding module from the front panel and observing the status and
error codes on the LCD display.
3.1.2 MA4011D (or MA4012D) Power/Control Module
DD IAGRAM IAGRAM 3.13.1C C :: FFRONT RONT PP ANEL ANEL - MA4011D P- MA4011D POWER OWER SS UPPLYUPPLY
* The MA4011D and the MA4012D power supplies have the same front panel functions and
displays. Diagram 3.1C represents both the MA4011D and the MA4012D.
DISPLAY
The first line on the display is the Mode Information Line. It shows the settings for the currently selected mode. The
possible operating modes depend upon the currently selected module. (See Section 3.2, Front Panel Operating
Modes (pp 14, 15) for a detailed description of the available modes).
The second line on the display is the Status Information Line. The Status Line is divided as follows:
The two leftmost characters are “mX” where X is replaced by the currently selected module address. Looking at
the front of the MA4000D system, the module addresses are assigned starting with module A in the leftmost slot in
the chassis and module K in the Power Supply. The modules in between are lettered B through J. (As shown in
Diagram 3.1A (p 12)). Modules can be installed in any open slot, and not all slots need to be filled.
The next two characters are “sXX” where “XX” indicate the status code for the currently selected module. Refer to
Section 5.0, Status Codes (pp 23, 24) for a list of current status codes.
The next two characters are “eXX” where “XX” indicates the error code for the currently selected module. (This
code is only displayed when it is non-zero). Refer to Section 6.0, Error Codes (pp 25, 26) for the list of current
error codes.
The final three or four characters of the second line can display the following information:
•
When under Remote Control and local control is disabled, it will read “RMT”
•
When under Local Control and a MA4040x card is selected, it will display the current firmware revision of the MA4040x
card (ex “r118”)
•
When under Local Control and a module other than a MA4040x is selected, this area will be blank
MODULE SELECT BUTTON
The MODULE SELECT button allows the user to select the module to display and/or control (the MODULE
SELECT LED will be lit on the selected module, and the LCD display will indicate the module address in the status
line).
MODE BUTTON
The MODE button allows the user to cycle through each of the various modes for the selected module.
UP/DOWN BUTTONS
The UP/DOWN arrow buttons adjust the settings for the currently selected mode.
POWER ON LED
When the green POWER ON indicator is illuminated, the module has been correctly installed and powered on.
POWERALARMMODULE
SELECT
AUX
SYSTEM 4000
POWER SUPPLY
WaveCom MA4011D
STATUS STATUS
24V
5V
10V
24V
5V
10V
DOWN UP MODEMODULE
SELECT