User Manual

ADCP-XX-XXX • November 2000 • Section 4: WMTS Installation
Page 4-1
 2000, ADC Telecommunications, Inc.
SECTION 4: WMTS INSTALLATION
Content Page
1 INTRODUCTION ................................................................................................................................................2
2 INSTALLATION..................................................................................................................................................2
2.1 Installing the WMTS..............................................................................................................................2
2.2 Connecting the Rear Panel...................................................................................................................4
2.3 Connecting the Front Panel .................................................................................................................6
2.4 Extracting and Inserting Cards............................................................................................................6
2.5 System Power-on..................................................................................................................................7
3 INSTALLING AND CONNECTING THE OUTDOOR UNIT.................................................................................8
3.1 RF Connection ......................................................................................................................................8
3.1.1 Upstream.................................................................................................................................8
3.1.2 Downstream................................................................................ Error! Bookmark not defined.
Warning: Carefully connect units to the supply circuit so that wiring is not overloaded
Warning: Read the installation instructions before you connect the system to its power source.
Warning: Do not touch the power supply when the power cord is connected. For systems with a power
switch, line voltages are present within the power supply even when the power switch is off
and the power cord is connected.
Warning: For systems without a power switch, line voltages are present within the power supply when
the power cord is connected
Warning: Before working on equipment that is connected to power lines, remove jewelry (including
rings, necklaces, and watches). Metal objects will heat up when connected to the power and
ground. This can cause serious burns or weld the metal object to the terminals