User Manual

ADCP-XX-XXX • November 2000 • Section 4: WMTS Installation
Page 4-4
 2000, ADC Telecommunications, Inc.
2.2 Connecting the Rear Panel
1. Connect the downstream RF cable to the F-type connector on the rear panel of the
downstream card (modulator panel) as illustrated in Figure 4-2.
2. Connect the upstream RF cable to the F-type connector on the rear panel of the upstream
card (demodulator panel) as illustrated in Figure 4-3.
Downstream
Hot Swap
IF Out
Tx
Active
Analog
Power
14195-B
RF
CONNECTOR
Figure 4- 2. Upstream card